![2000 toyota camry sun visor replacement](https://cdn2.cdnme.se/5447227/9-3/16_64e61dfc9606ee7f98e9879e.png)
![2000 toyota camry sun visor replacement 2000 toyota camry sun visor replacement](https://images-na.ssl-images-amazon.com/images/I/71C4ylrri6L._SL1500_.jpg)
If it doesn't seem to go all the way in, then push it it while rotating it, and it should snap back into position.
![2000 toyota camry sun visor replacement 2000 toyota camry sun visor replacement](https://i.ebayimg.com/images/g/56YAAOSwyHxcY7JV/s-l300.jpg)
If your flat area is missing, and the repaired visor doesn't operate properly, then you might see where that surface is on the other visor and file it flat in the proper place on the repaired visor.Īlign the pin in its hole, and drive it back in, using a board to prevent damage to the mounting bracket. On mine there was an undamaged flat area which must serve some purpose. I then filed the solid JB Weld level with the remainder of the pin. I undercut the edges of the missing area and over-filled it with 5 minute JB Weld, smoothing it out until it no longer flowed easily. On mine, a small area of plastic was gone, evidently where it had worn away on the band around the pin which provides tension to hold it in place. I placed a 1/2" square board about 8 inches long against the angle and struck it firmly until the pin came out, with the edge of the visor body on the floor. Remove the screws and dismount the visor.Īlign the pin with the visor with the angle away from the visor, and drive the pin out of the visor. Remove the cap that covers the attaching screws. I had a driver side droop on my 2002 Highlander, only about half-way so not a hazard, and no wiring, and was able to repair it as follows.
![2000 toyota camry sun visor replacement](https://cdn2.cdnme.se/5447227/9-3/16_64e61dfc9606ee7f98e9879e.png)